Chapter 44 - Valances

Valances are decorative finishes for the tops of draperies. With rooms with low ceilings, start valance at ceiling. A simple valance has already been described (p. 211). Circular, pleated and gathered flounces can be used for attractive valances. A casing is made at the top for the outer rod on which the valance is placed. Valances are usually lined. They may even be sewed onto the top of the curtain or drape for an informal room.

Other valances are sewed onto stiff boards or wood. Sometimes these are called cornices to distinguish them from soft valances with no stiffening in the back. The boards are cut straight or are shaped (lumber yards will cut out wood pieces to your measurements), and are attached to the window frame with brackets. The depth is usually from six to twelve inches.
 
The fabric, either matching or contrasting, is cut to fit board, plus one-inch seam allowance all around. Cut lining piece and buckram to size without seam allowance. Fold back seam all around on valance piece and press, creasing sharply. Insert buckram under turned-back edges and baste. Turn in edges of lining ½ inch and place over valance, wrong sides together (lining will be a little smaller than valance), and baste edges together. Whip a piece of twilled tape to top and tack this tape over the top of the wood board, using ordinary tacks. The valance should go straight across the board and around back to the wall. These two short side sections are called the returns. Allow fabric for this when cutting.

Valances may be quilted, decorated with appliqué, ball fringe, or braid. They may be scalloped at the bottom, using a pattern made out of paper to shape the scallops. Reread directions for making scalloped flounce, p. 200.

For swag effect, use a width of fabric with ends cut diagonally. Hem edges and drape over tie-back pins or through rings. Experiment before cutting to get proper effect.

Are You Ready To Move Onto The Next Lesson? Click Here...